For Immediate Service Call Mark

952-380-9916

Seamless Gutters

Use a Top Rated Seamless Gutter Service and Protect Your Home

First Choice Seamless understands how important your home is. It is the largest investment most people make in their lives.

Gutter Coil

Our gutter coils are Baked on enamel finish with a thickness of .032" for maximum strength and durability. We have 75 colors available as well as copper.

Hangers

We use a upgraded RAYTEC hanger

In the absence of a standardized test in the gutter industry that could be used to evaluate the pull value of hangers, Raytec developed the test procedure demonstrated below.
The procedure consists of a set of gripper hooks attached to the outside edge of .032 Aluminum gutter. Standard hidden hangers were screwed into a 3/4" fascia board backed by 2" x 4" spruce, with a 1 1/2" hex head screw. A screw jack was used to pull the gripper hooks at an angle of 45% with an "S" type load cell measuring the lbs. of force exerted on the hanger. Displayed on a Total comp electronic digital indicator, each hanger was evaluated for the amount of sag it displayed at various weights and, finally, the point at which it broke.

Our tests are in no way intended for use other than comparing one hanger with another. Twelve hangers of similar mounting configuration, commonly used in the gutter industry, were evaluated. The Raytec Hangtite™ proved superior to all of the hangers tested. Of the total tested, the Raytec hanger is priced at about the mean average of the group.

Findings:

At 119 lbs. pull, 4 of our competitors' hangers broke loose.

At 140 lbs. pull, 3 more of our competitors' hangers broke loose.

At 230 lbs. pull, 4 more of our competitors' hangers broke loose.

The Raytec Hangtite™ hidden hanger hold up to 297 lbs!

Downspouts

Downspouts are finished to match the siding and are available in both a 2" x 3" as well as a 3" x 4".

Flashing

Gutter flashing is aluminum and approximately 3" x 4". Gutter flashing is located under the shingles and prevents water form entering the area behind the gutter and rotting your soffit.

Fasteners

We Also use a #10 1 ½ screw Not #8. We never use nails on any installation. Since we use only the highest quality products on all gutters we install, all workmanship comes with a lifetime warranty. Installation is by our own experienced installers NOT SUBS insuring your complete satisfaction with every job.